Lab Armor Thermal Beads 8 Liter

  • $571.00



    Lab Armor Thermal Beads – 8 Liter

    Update Water Baths & Ice Buckets with Beads


    Lab Armor® Beads are small, dry, metallic thermal beads designed to replace water in laboratory water baths and ice in ice buckets. Their high thermal conductivity technology is patented and improves energy efficiency of standard water baths by over 50%.

    Eliminates the mess of melting, condensation. Reduces on-going ice consumption.

    Freeze and re-freeze!  These thermal beads will retain temperatures and do not melt. Improve lab cleanliness when using thermal beads in place of fluid in water baths.


    Thermal Bead Features
    • Metal composition with smooth round surface
    • Moisture and gas impermeable
    • High thermal conductivity
    • Working temperature range is -80°C to 180°C
    • Non-toxic, non-vaporizing material
    • Recyclable!



    Learn More

    Are Lab Armor beads autoclavable?
    They are not. The steam and pressure ruins the surface of the beads.We recommend a dry heat sterilization: 180 degrees for 2.5 hours. For a quick touch up we recommend spritzing with 70% ethanol and stirring. If some debris falls into the beads we recommend placing them in a pail with water and a small about of Dawn, rinsing out multiple times, and then putting through the dry heat sterilization process.


    How long can I use Lab Armor Beads under normal conditions?
    Under normal conditions, Lab Armor Beads should last the life of the water bath. If used incorrectly or if not maintained and cleaned properly, the surfaces of Lab Armor Beads can become damaged, resulting in a loss of fluidity of the bath, but not in thermal performance. We recommend that you avoid strong detergents, acids and bases. Bleach, for instance, may tarnish the surface of the Lab Armor Beads reducing its fluidity and overall performance.


    What is the general temperature performance of the beads at high & low temperatures?
    Beads have been tested using various water bath models at a range of temperatures. In most traditional water baths, the further the set temperature is from ambient temperature, the greater the thermal gradient will be in the bath. Therefore, at an operating temperature of 37ºC to 42ºC, the thermal gradient in a common water bath is typically +/-1-3ºC, whereas at 55-65ºC it is closer to +/-3-8ºC depending on the design of the bath and the amount of Lab Armor Beads used. For applications that require greater temperature control, a Lab Armor Bead Bath can be used.


    Can Lab Armor Beads be used as an ice bath?
    There are a number of different ways to use Beads. Many customers place containers of Beads in their refrigerators, incubators and ovens.

    When creating an ice bath, one goal is to keep the Beads dry. So it’s a good idea to separate the Beads from the ice packs, which accumulate condensation. We recommend using some kind of mesh wire or fabric. Also, any condensation that builds on the surface of the Beads will be able to drip through the mesh. It’s important to keep the Beads from soaking in water for extended periods of time. Besides attracting contamination, excessive water contact will tarnish the surface of the Beads and reduce the fluidity of the bath. Also, as an alternative to ice packs, dry ice can be used to make a colder bath (<0 ºC).


  • Specifications

    Lab Armor Thermal Beads

    8 Liter

    SKU# 42370-004

    ~5 – 8 mm

    ~ 1 – 2 mm

    ~ 3.65 lbs per liter